| | | |
|
|
|
|
|
7.5 diff cover set up. - Mike Campbell (Mike) Viewed: 292 times.
|
7.5 diff cover machined flat with 4" face mill. - Mike Campbell (Mike) Viewed: 258 times.
|
7.5 diff cover machined with .0625" end mill .030" deep. - Mike Campbell (Mike) Viewed: 267 times.
|
7.5 diff cover glass bead blasted (owner plans to paint the letters). - Mike Campbell (Mike) Viewed: 265 times.
|
| | | |
| | | |
|
|
|
|
|
7.5 diff cover fuzz cut .002" after bead blasting to preserve machined face. - Mike Campbell (Mike) Viewed: 295 times.
|
Custom made horn button from scratch for steering wheel. Engraved with a .010" tip carbide air motor. - Mike Campbell (Mike) Viewed: 282 times.
|
Engraved EGR block off plate done with .010" tip carbide air motor. - Mike Campbell (Mike) Viewed: 274 times.
|
Custom horn buttons. - Mike Campbell (Mike) Viewed: 278 times.
|
| | | |
| | | |
|
|
|
|
|
Polished and engraved turnbuckle on three sides for alternator. - Mike Campbell (Mike) Viewed: 272 times.
|
Setting up spoil plate that is used to cut and engrave EGR block off plates on. - Mike Campbell (Mike) Viewed: 250 times.
|
8.5 diff cover set up. - Mike Campbell (Mike) Viewed: 259 times.
|
Engraved EGR block off plate done with .010" tip carbide air motor. - Mike Campbell (Mike) Viewed: 412 times.
|
| | | |
| | | |
|
|
|
|
|
8.5 diff cover milled flat with .750 bull mill before engraving with .047" end mill. - Mike Campbell (Mike) Viewed: 282 times.
|
Engraved after being glass bead blasted. - Mike Campbell (Mike) Viewed: 271 times.
|
Start of a custom horn button. - Mike Campbell (Mike) Viewed: 281 times.
|
Steering wheel getting sanded and rebuffed. - Mike Campbell (Mike) Viewed: 251 times.
|
| | | |
1
